Installation requirements – Viking DFB450 User Manual
Page 3
A 2” cut-out is required
for water supply and
discharge lines.
24”
(61.0
cm
)
24
”
(61
.0
cm
)
34”
min
.
(86.4
cm
)
to
35”
max
.
(89.0
cm
)
KITCHEN CLEANUP
Built-In 24”W. Dishwasher 450
P L A N N I N G A N D D E S I G N G U I D E
V I K I N G R A N G E . C O M
•
1 - 8 8 8 - V I K I N G 1
UTILITY
REQUIREMENTS
GAS
Not applicable
ELECTRICAL
• 3’9” (1.1 m),
electrical cord with 90
degree 3-prong plug
• 120V/60 Hz
• Maximum amp
usage—15.0 amps
• Water-heating
element rating—
1,400 watts
PLUMBING
• 120°F (49°C) hot
water recommended;
dishwasher will,
however, perform
properly with cold
water*
• Inlet water pressure
operating range—
10 – 125 psi (0.69 –
8.62 bar)
• Five foot (1.5 m)
braided stainless steel
water line with 3/8”
(0.95 cm)
compression fitting
supplied with
dishwasher
• Seven-foot (2.13 m)
1/2” (1.3 cm) ID
“crimp-proof”
flexible drain hose
with clamp attached
to dishwasher;
connections provided
for 5/8” (1.5 cm), 3/4”
(1.9 cm), or 1” (2.5
cm) cut as required
• High loop of drain
hose required; min.
height from floor—
20” (50.8 cm)
• Check local codes
for drain air gap
requirement
*Cycle times will be
extended
Installation Requirements
ACCESS REQUIREMENTS
All models
Cutout width
24” (61.0 cm)
Cutout height
34” (86.4 cm) min. to 35” (89.0 cm) max.
Cutout depth
24” (61.0 cm)
See Custom Panels section for
more information and additional
specifications.
VDB450
Professional
Built-In Dishwasher
DFB450
Custom Front
Built-In Dishwasher
R E V I S E D 7 / 1 4 / 1 0
© 2 0 1 0 V R C — INFORMATION SUBJECT TO CHANGE