Vinotemp VinoCave Series - Manual (Page 13)

12 1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
TROUBLESHOOTING
SYMPTOM POSSIBLE CAUSE
Vibrations • Check to make sure the wine cellar is on a level surface.
The door will
not close
• The wine cellar is not on a level surface.
• The racks are out
properly. • A bottle is too long.
of position.
Unit has no
• Make sure unit is plugged into wall socket.
• Check the wall outlet for po
power/does a wall switch.
not operate. • Make sure the wall socket is functional by testing another electrical
appliance in the powe
wer. Make sure the outlet is not controlled by
r socket.
The inside
temperature • Make sure the cooling vents are not obstructed.
e is 90°F or higher,
desired temperature.
does not seem
correct.
• When using the unit for the first time, it can take up to 24-48 hours to
reach the
• The room may be too hot. If the ambient temperatur
the unit can have difficulty chilling adequately.
Power is ON
but the unit
will not cool. o
In a room with poor air circulation such as a garage, closet,
another heat-producing appliance such as a dishwasher, oven or
refrigerator.
o
With an outlet shared with a refrigerator, as the refrigerator
power from the wine cellar.
o
In a cabinet or closet.
• Make sure the grill area at the back of the cabinet is clean and
• Allow at least 24-48 hours for the internal temperature to initially adjust.
• If the room temperature is above 90°F, the unit can have difficulty
cooling. Humidity does not affect the cooling ability of the unit.
• To achieve accurate temperature control, the unit should not be u
operated in any of the following locations:
sed of
o
In a sunny place
near
will drain
unobstructed.
• Ensure that the temperature SET values comply with the given
temperature range
Compressor
• Place your hand on the condenser (metal grill located along the ext
wall behind your cabi
will not turn
ff
erior
net). If the condenser is cold, contact for service.
• If the condenser is hot, turn the cold adjuster to its highest level. If
compressor still does not stop (after waiting a short period of time for
cabinet to adjust), contact for service. o
Warning: Technical service being done on your Vinocave withou
approved by Vinotemp may lead to your w t being pre-
arranty being considered null and
void.