Danger – Viking F20050 EN User Manual

Page 9

LIGHT TUBE REPLACEMENT - 24” W. Models

otte

e:: Please contact your Viking Range Corporation parts distributor or dealer to order new light tubes. Use only approved

replacement light tubes from your dealer or manufacturer.

Failure to disconnect the power cord when changing the light tube may result in electrical
shock.

This product uses two 6-watt light tubes to illuminate the interior
of the wine cellar. The light tubes are very reliable electrical
components, but should either or both light tubes not function
properly, please call your local dealer for replacement light tubes.
To replace the light tube:
•Use a small Phillips head screwdriver to remove the two screws

holding the cover plate over the back section of the light tube.
Set the screws and cover plate aside for re-assembly later.

•Using a small flat-blade screwdriver, gently lever the front section

of the light tube down to allow it to be pulled clear of the light
housing. Disconnect the two insulated electrical connectors from
the cabinet's electrical cable and discard the old light tube.

•Reconnect the insulated electrical connector of the new light tube

to the cabinet's electrical cable connectors. Make sure they are
secure and fully inserted.

•Carefully realign the light tube's electrical terminals back into the rear of the light enclosure channel making sure not

to crimp them. Gently insert the light tube along the length of the light enclosure channel. Press the light tube gently
into the light enclosure channel. Only a small part of the light tube should project below the ceiling of the wine cellar.
DO NOT USE A HAMMER TO FIT THE LIGHT TUBE.

•Place the light tube terminal cover plate back in its original position on the light enclosure's flange. Re-use the

original two screws to secure the cover in place. Plug the wine cellar into the electrical socket. Check to see if the
light tubes operate properly.

Light tube

Connectors

Cover plate

Screws

LIGHT ASSEMBLY REPLACEMENT - 15” W. Models

NOTE

: Please contact your local Viking Range

Corporation parts distributor or dealer to order new light
assembly.

To replace the light, first disconnect the wine cellar’s
power cord. Next, remove both the green ground wire
screw located on the left of the light assembly and the
other screw located on the right of the light assembly with
a 5-16” hex head screwdriver. (See drawing). Unplug the
light unit and remove complete light assembly.

To install the new light assembly, screw in the green ground wire screw and the screw
located on the right with a 5/16” hex head screwdriver and plug the light unit in.

Plug

Hex head
screw

Light
assembly

Green
ground wire

Hex head
screw

Failure to disconnect the power cord when changing the light tube may result in electrical
shock.

DANGER