Viking 325E - Manual (Page 11)

20 21
Installation Procedure (cont’d.)
11A Air Gap
(Discharge with food waste disposer and air gap)
11B Air Gap
(Discharge with air gap)
Connect water line.
12 13
Plug LED light into dishwasher (select
models only) and install kick plate.
Performance Checklist
Testing for Leaks
A qualified installer should carry out the
following checks:
h Remove packaging and parts.
h Turn on the water supply and check for
leaks.
h Turn the power on at breaker/fuse box
and test the dishwasher operation by
running a rinse and hold cycle. (This
should take about 12 minutes.)
h Turn off the electrical power and check
for leaks under the dishwasher.
h Make sure that no kinks have developed
in the drain lines.
Final Preparation
• Some stainless steel parts may have a
plastic protective wrap which must be
peeled off.
Cycles Options
Unit Reset
• If the unit should need to be reset for any
reason, push and hold the “START” button
for 4 seconds.