Setup menu – Vivitar Vivicam 3715 User Manual

Page 43

Setup menu

You can select your preferences for the camera settings in SET-UP mode. Turn the
mode dial to SET-UP mode and navigate to the option you wish to configure by
using the

button.

Format

This option formats the internal memory (or
memory card) and erases all stored images and
data. To perform the format function, first press
the button. Then select [Yes] by using the

button and press O K . A progress bar

displays, showing the progress of formatting.

Beep

The camera makes a sound (beep) each time
you press the camera button if this function is
enabled. Press the button. Select [On] or [Off]
by using the

button and then press OK.

Power off

If the camera goes unused for a certain period
of time while the camera is powered on, the
camera will switch to an idle mode, and eventu-
ally turn itself off to conserve power.

Inactivity period

Camera status

(batteries)

(AC power adapter)

60 seconds

stay idle

30 minutes

shut off

If the camera is idle, re-activate the camera by pressing any button or switch the
mode dial. If the camera has powered-off you must turn the camera on again by
pressing the

button. The table (above) shows the default time settings for idle,

and power-off. To change the power saving interval, first press the button. Then
select the power-off interval you perfer by using the

button and press OK.

[3 min], [5 min], [10 min], [30 min]