VTech CS6114-2 - Manual (Page 7)

4
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery
status (see the table below). If necessary, place the handset in the
telephone base or charger to charge the battery. For best performance,
keep the handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See the table
on page 25 for battery operating times.
If the screen is blank, you need to charge the handset without interruption
for at least 30 minutes to give the handset enough charge to use the
telephone for a short time. When the battery is low, the handset displays
Low battery along with a flashing icon. If you are on a call in low battery
mode, the handset beeps every 50 seconds.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank,
or displays Place in
charger and flashes .
Battery has very little or
no charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and
flashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X and
--:-- --/--.
Battery is charged. To keep the battery charged,
place it in the telephone
base or charger when not
in use.
If you place the handset in the telephone base or charger without plugging
in the battery, the screen displays No battery.
/FIND HANDSET
Press once and then release to page
all system handsets (page 12).
IN USE light
On when the handset is in use.
Flashes quickly when there is an
incoming call.
Flashes when another telephone
sharing the same line is in use.
Telephone base layout