Circuit diagram troubleshooting, Troubleshooting, Circuit diagram – Vinotemp VT-SC-1 User Manual
Page 6
6
W W W . V I N O T E M P . C O M
TROUBLESHOOTING
If your cooler does not work properly, please note the following suggestions
before you attempt to repair or replace the unit.
Your cooler does not work:
• Check the electrical outlet for power and that the plug is properly plugged
in.
• Check the condenser for proper cleaning.
• The circuit breaker is tripped or the fuse is blown.
Your cooler makes too much noise:
• Check that the cooler is level.
Compressor turns on and off frequently:
• The room temperature is higher than normal.
• The door is not closed completely.
• The door gasket is not sealed well.
• There is insufficient clearance around the cooler.
• The cycling frequency will reduce when all of the cans reach the set
temperature.
The following is not a malfunction:
• It is normal to hear gurgling sounds caused by the flow of refrigerant
when each cooling cycle ends.
CIRCUIT DIAGRAM
sensor
Computerized
Controller
Overload
Protector
Compressor
C
M
S
PTC Starter
Starter
S
Impedance coil
Control Enclosure
L
N
E
115V 60Hz
Li
gh
t