Maintenance, Getting started, Accessories – Venturer PVS7980 User Manual
Page 5

E - 5
heart shaped, octagonal, etc.). They may cause
malfunctions.
CLEANING THE UNIT
• Be sure to turn the unit off and disconnect the aC
power cord before maintaining the unit.
• Wipe the unit with a dry soft cloth. If the surfaces
are extremely dirty, wipe clean with a cloth that
has been dipped in a weak soap-and-water
solution and wrung out thoroughly. Then wipe
with a dry cloth.
• never use alcohol, benzene, thinner, cleaning
fluid or other chemicals. Do not use compressed
air to remove dust.
IMPORTANT NOTE
Before transporting the unit, remove the disc from
the disc compartment.
CLEANING THE DISC
A defective or soiled disc inserted into the unit
can cause sound to drop out during playback.
Handle the disc by holding its inner and outer
edges.
• Do not touch the surface of the unlabeled
side of the disc.
• Do not stick paper or tape on the surface.
• Do not expose the disc to direct sunlight or
excessive heat.
• Clean the disc before
playback. Wipe the disc
from the center outward
with a cleaning cloth.
• neVer use solvents such as benzine or
alcohol to clean the disc.
• Do not use irregular shaped discs (example:
MAINTENANCE
USING THE REMOTE CONTROL
• Point the remote control at the remote
SENSOR located on the unit.
• When using this unit in bright light, the infrared
REMOTE CONTROL SENSOR may not work
properly.
• the recommended effective distance for using
the remote control is about 16 feet.
TO CHANGE REMOTE BATTERy
BATTERy REPLACEMENT
When the battery becomes weak, the operating
distance of the remote control will be greatly reduced
and you will need to replace the battery.
Note:
• If the remote control is not going to be used for
a long time, remove the battery to avoid damage
caused by battery leakage corrosion.
• When discarding battery, environmental
problems must be considered and local rules
of laws governing the disposal of this battery
must be followed strictly.
CAUTION:
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
GETTING STARTED
Remove the PVC sheet
before
operating
the
Remote Control.
WARNING:
• Do not dispose of batteries in a fire. they may
leak and/or explode.
• the battery should not be exposed to excessive
heat such as sunshine, fire or the like.
1. Open the battery
door.
2. Insert one
CR2025 (3V)
size battery.
Remote Control (with battery) ......... x 1
Car Power Adapter .......................... x 1
ACCESSORIES
PLEASE LOCATE THE INCLUDED ACCESSORIES.
to order replacement units, visit http://www.venturer.com
DC-AV Cable .................................... x 1
Straps ................................................ x 2
811-798191W012.indd 5
4/1/2008 5:00:57 PM