ViewEra V220 - Manual (Page 7)

2.2.4 Installing the monitor base
1. Take the monitor and the base out of the box and place its side on the table.
2. 1 For V193 and V220 series, align the three bolt holes on the monitor base with the three bolt
hoes on the monitor arm, and then screw the threes bolts with a screwdriver.
2.2 For V202 series
(1) After taking the monitor out of the carton, carefully turn the monitor screen face down.
(2) Align the base with the knighthead of the monitor and push the base in the direction of arrows
until the fasteners both on the knighthead and the base are well connected.
(3) Insert the plastic pin into the base in the direction of arrow, then use screwdriver to lock the
bolt firmly.
(a) V193 and V220 series (b) V202 series
2.2.5 Power on
Turn on your monitor and computer. The LED indicator will light green (or blue) when the screen is
under normal condition. If the LED indicator lights red, please check if the signal cable is securely
connected between the computer and the monitor.
5