ViewEra V220 - Manual (Page 15)

8. Troubleshooting
1) No image
 Check if the power cord、the monitor and the power plug are well connected.
 Check if the monitor is off, please contact [email protected] for assistance.
2) “No Input Signal” appears.
 Check if the VGA cable is tightly connected between the video output connector on the video
card and the video input connector on the monitor.
 Check if your video card driver is correctly installed. If possible, please re-install or update your
video card driver.
3) The image is blurry or not positioned correctly.
 Enter the Image menu in the OSD and then select “ Auto Adjust ” to adjust the display to optimum.
 Refer to Chapter 2.6, set your monitor to its native resolution of 1680 by 1050.
4) The color is abnormal
 Check the connection of signal cable and make sure the two screws on the connector are
securely tightened.
 Chick if there is any pin on the signal cable bent or broken off. If there is, it is required to replace
the signal cable.
 Enter the Color Temperature menu and select AUTO Color to recall the factory settings for color
hue.
13