Vision Fitness 2200 HRC - Manual (Page 6)

Step 5 • Pedals
1: Identify the left and right Pedals (152) and the left and right Pedal Straps
(199). Attach the correct straps to each pedal, then thread each Pedal
into the correct left and right crank arms and tighten.
NOTE: It is very important to FULLY TIGHTEN each pedal. Failure to do
so will result in loosening and NOISE.
Step 6 • Console Mast
1: Unfold the Console Cable (75) that is folded into the Frame Console
Mast bracket. Straighten this cable and remove any kinks by drawing the
cable through your fingers. Find the string that is attached to the inside
of the Console Mast (101), but do not remove yet.
2: Slide the Rubber Console Mast Cover (88) onto the Console Mast (101)
until it is above the first waterbottle screw.
3: Now attach the Console Cable (75) to the string located inside the
Console Mast. Holding the Console Mast (101) above the Frame Console
Mast Bracket, guide the Console Cable (75) through the Console Mast
while simultaneously sliding the Console Mast onto the frame bracket.
4: Bolt the Console Mast (101) to the frame using the six Console Mast
Allen bolts (182). Make sure these bolts are very tight. Now slide the
Rubber Console Mast Cover (88) back down to cover the bolt heads.
R2200
Assembly