Vivotek IP7152 - Manual (Page 8)

- 7 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Installation
In this manual, "User" refers to whoever has access to the Network Camera, and
"Administrator" refers to the person who can configure the Network Camera and grant
user access to the camera.
Hardware installation
Please verify that
your product package
contains all the
accessories listed in
the foregoing Package Contents. Depending on the
user’s application, an Ethernet cable may be needed.
The Ethernet cable should meet the specs of UTP
Category 5 and not exceed 100 meters in length.
Upon powering up, the status LED lights red first and then the device will go through
booting process. The status LED will be steady green while getting IP address. After that,
it will blink green every other second as heartbeats to indicate alive.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet
cable plug in the power adapter. If the LED turns out to blink green-color, go to next
paragraph “Software installation”. For IP7152, if the Ethernet is not available, it will
switch to wireless LAN mode.
This Network Camera provides a general I/O terminal block with one digital input and one
Connect the power adapter jack to the Network
Camera before plugging in to the power socket. This will
reduce the risk of accidental electric shock.