Valor Auto Companion Inc. DV-180 - Manual (Page 6)

4 13
Figure: Electrical Connections1 Figure: Electrical Connections1
Additional lnformation
Notes:
To avoid shorts in the electrical system,be sure
to disconnect the power cable before beginning
installation.
Refer to the owner`s manual for details on
connecting the power amp and other units,then
make connections correctly.
Never feed power to other equipment by cutting
the insulation of the power supply lead of the
unit and tapping into the lead . The current
capacity of the lead will be exceeded, causing
overheating.
When replacing fuse, be sure to use only fuse
of the same rating prescribed on this unit.
With DVD-R/DVD-RW discs,only recordings
made in the video format ( Video mode ) can
be played back . DVD - RW discs recorded in
the Video Recording format (VR mode ) cannot
be played back.
Even with DVD-R/DVD-RW discs featuring
recordings made in the Video format ( Video
mode ) , playback may not be possible with
this unit due to disc characteristics or scratches
or dirt on the disc. Dirt or condensation on the
lens inside this unit may also prevent playback.
Playback of discs recorded with a PC using
the correct format is possible but depending
on the application software , environmental
settings and other factors playback may not be
possible ( For details , inquire at the store or
dealer where you purchased the application
software.)
CD - Extra discs can be played back as music
Cds.
Normal playbackable discs are CD-R/CD-RW
other than those recorded with a music CD
recorder.
Playback of music CD-R/CD-RW discs even
than those recorded with a music CD recorder,
may not be possible with this unit due to disc
characteristics or dirt on the disc . Dirt or
condensation on the lens inside this unit may
also prevent playback.
Titles and other text informations recorded on
a CD-R/CD-RW discs can not be displayed by
this unit.
If you insert a CD-RW disc into this unit to
playback,it will take a bit longer time than when
you do with a conventional CD or CD-R disc.
Read the precautions with the CD-R/CD-RW
discs before using.
Disc Cleaning
Use a dry soft cloth to wipe the surface. If
the disc is quite dirty, use a soft cloth slightly
moistured with isopropyl (rubbing) alcohol.
Never use solvents such as benzine , thinner
or conventional record cleaners as they may
mar the surface of the disc.
Note:
A disc may become somewhat scratched
(although not enough to make it unplayable)
depending on how it is handled and the
conditions of exposure. Note these scratches
are not an indication of any problem with the
player.
Preparing New Discs with
Rough Spots
A new disc may have rough edges on its inside
and outside edges. If a disc with rough edges is
used , the proper setting will not be performed
and the player will not play the disc. Therefore,
remove the rough edges in advance by using a
ball point pen or pencil as shown on the right .
To remove the rough edges , press the side of
the pen or pencil against the inside and outside
edges of the disc.