Door disassembly – Viking DMOC205SS User Manual

Page 36

DMOC205SS
VMOC205SS

7. Make sure the door is parallel with oven face lines (left

and upper side lines) and door latch heads pass through
latch holes correctly.

8. Insert the lower oven hinge into oven cavity bottom

flange and then engaged the door hinge pin. Then
secure the lower oven hinge firmly with tree (3) mounting
screws.

Note:

After any service to the door;

(A) Make sure that door sensing switch and secondary

interlock switch are operating properly. (Refer to
chapter "Test Procedures".).

(B) An approved microwave survey meter should be

used to assure compliance with proper microwave
radiation emission limitation standards.

DOOR ADJUSTMENT
The door can be adjusted by keeping screws of each hinge
loose.

After adjustment, make sure of the following :
1. Door latch heads smoothly catch latch hook through

latch holes and that latch head goes through center of
latch hole.

2. Deviation of door alignment from horizontal line of cavity

face plate is to be less than 1.0mm.

3. Door is positioned with its face pressed toward cavity

face plate.

4. Re-install outer case and check for microwave leakage

around door with an approved microwave survey meter.
(Refer to Microwave Measurement Procedure.)

Note:

The door on a microwave oven is designed to act as
an electronic seal preventing the leakage of
microwave energy from oven cavity during cook

Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
1. Place door assembly on a soft cloth with latches facing

up.

Note:

As the engaging part of choke cover and door panel

are provided at several places, do not force any particular
part.

2. Insert an putty knife (thickness of about 0.5mm) into the

gap between the choke cover and corner portion of door
panel as shown Figure C-6 to free engaging parts.

3. Lift up choke cover.
4. Now choke cover is free from door panel.

DOOR DISASSEMBLY

Figure C-6. Door Disassembly

cycle. This function does not require that door be
airtight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven
cavity. If such were the case, your oven could not
be equipped with a vent, the very purpose of which
is to exhaust the vapor-laden air from the oven
cavity.

Figure C-5. Door Replacement and adjustment

RE-INSTALL

LOWER OVEN HINGE

UPPER OVEN HINGE

DOOR ASSEMBLY

LATCH
HEADS

CHOKE COVER

PUTTY KNIFE

FRONT

INSIDE

Upper

Lower

Bent

Door
Panel

Choke
cover

1 BENT

2 LIFT UP

This manual is related to the following products:

VMOC205SS