Programming – Viper 3303 User Manual
Page 40
37
© 2009 Directed Electronics. All rights reserved.
can be performed by pressing one of the command buttons.
Programming
To enter; hold the
button for 8 seconds until the transmit LED turns on,
the programming main menu has been accessed (If programmed to
operate two systems, ignore the transmit LED flashes at 3 seconds).
To exit; press and release the
button to go back and repeat to exit.
The transmit LED turns off when programming is exited.
Sensor Adjust
The
button is used for sensor adjustment, to avoid unintended
alarm triggers, it is recommended that an authorized Directed
dealer perform all sensor adjustments.
Remote Features Menu
Press and release the
button, 2 transmit LED flashes indicate
the remote features menu is accessed and can be set. Press the
buttons indicated below, 1 flash turns the feature on, 2 flashes
turns the feature off.
Autolock feature: Press
s
to turn on/off.
Car 2 feature: Press
s
to turn on/off.
Remote Learning
Press the
button,3 transmit LED flashes indicates the remote is
ready to program to the system.
Per the instruction in Pair the Responder LC remote control under
the Main Menu section of this guide, following step 3 of Prepare
the system. Press and hold the
button, the siren emits one
long chirp to confirm the remote has been learned.