Venturer CD2088 - Manual (Page 4)

- E4 -
SYSTEM CONNECTIONS
IMPORTANT
Switch off the power before connecting speakers and
other equipment.
SPEAKER CORD CONNECTION
Connect the wires with the printed red lines to the red
(+) terminals and the plain-black wires to the black (-)
terminals.
NOTE : Connecting speakers other than the speakers
supplied with the unit, may damage the unit.
POWER CORD CONNECTION
1. Make sure that all the components and speakers are connected correctly.
2. Check that the rated voltage of your unit matches your local voltage.
CAUTION
To prevent electrical shock, match wide blade of plug to wide slot, fully insert. (For USA and CANADA only)
CAUTION
• Be sure the AC power cord is disconnected and all functions are off before making connections.
• When you are not going to use the unit for a long period of time, disconnect the AC power cord.
SPEAKER CONNECTIONS
Connect Speaker wires (Left & Right) from the Speaker to the amplifier's Speaker terminals.
NOTE :
Ensure in each case that the striped (+) wire is connected to the (+) terminal of the speaker
output and the non-striped wire (-) is connected to the (-) terminal of the speaker output. Also
ensure that the correct orientation for left and right main speakers is observed.
Connect the plug of the Right Speaker to the Speaker LED (R) jack, the other plug of the Left
Speaker to the Speaker LED (L) jack and the SPEAKER LIGHTS will light up and control by volume.
SPEAKER TERMINALS IMPEDANCE: 8 ohm (
Ω
)
CONNECTION WITH OTHER OPTIONAL EQUIPMENT
To listen to or record audio signals from external units through this unit:
Connect the white plug to the L jack, and the red plug to the R jack of the AUX IN connector.
LISTENING TO THE CONNECTED EQUIPMENT
1. Press the FUNCTION button to AUX.
2. Play the external source.
NOTE :If the external equipment is a television and this audio system is close to it, you may experience
interference if the tuner function is selected while the television is working.
TO TURN ON THE UNIT
Press the POWER button. The display will light up. Select the desired function and the corresponding
function indicator will light up.
AFTER USE
Press the POWER button. The display light will fade and only the clock display will be shown.
AC Cord to an AC outlet
2088_eng1.PMD 10/29/2004, 2:54 PM 4