Venturer CD2088 - Manual (Page 10)

- E10 -
PRESET TUNING
1. Press the FUNCTION button
to TUNER.
2. Press the BAND button to
select the a band.
3. Press the PRESET buttons
to preset number.
TUNING INTO A PRESET STATION
1. Press the FUNCTION button
to TUNER.
2. Press the BAND button to
select a band .
3. Tune into a station.
4. Press the MEMORY/
CLOCK button.
5. Use the UP/DOWN buttons
to select the pre-set number.
6. Press the MEMORY/
CLOCK button to store the
station to the pre-set number.
The contents (preset channel number, frequency and frequency band) which have been stored
in memory will appear on the display in numerical order, irrespective of the frequency bands.
FOR BETTER RECEPTION
FM
Fully unwind the wire antenna. Then extend the
wire antenna and place it in the position that
sounds best.
NOTE: Do not connect to outside antenna.
AM
Connect the loop aerial (provided) to the
'AM LOOP ANTENNA' snap terminals at the
back of the unit. Position the aerial for the
best reception.
2088_eng2.PMD 10/29/2004, 2:55 PM 10