VTech DECT DS6121-2 - Manual (Page 57)

www.vtechphones.com 53
Appendix
Troubleshooting
Problem Suggestion
The battery does not
charge in the handset
or the handset battery
is not charging.
Make sure the handset is placed in the telephone base or charger correctly. The CHARGE
light on the handset should be on.
Remove and reinstall the battery, then charge for up to 16 hours.
If the handset is in the charger or in the telephone base but the
CHARGE light on the handset
is not on, refer to The CHARGE light is off in this section.
It may be necessary to purchase a new battery. Please refer to the Battery section (page 50)
of this user’s manual.
The telephone might be malfunctioning. Please refer to the
Warranty section (page 63) of this
user’s manual for further instruction.
•
•
•
•
•
The CHARGE light is
off.
Clean the charging contacts on the handset(s) and telephone base each month using a pencil
eraser or a dry non-abrasive fabric.
Make sure the power adapter and telephone line cords are plugged in correctly and securely.
Unplug the power adapter. Wait for 15 seconds before plugging it back in. Allow up to one
minute for the handset and telephone base to reset.
The telephone might be malfunctioning. Please refer to the
Warranty section (page 63) of this
user’s manual for further instruction.
•
•
•
•
There is no dial tone. First, try all the above suggestions.
Move the handset closer to the telephone base. It might be out of range.
The telephone line cord might be malfunctioning. Try installing a new telephone line cord.
Disconnect the telephone base from the telephone wall jack and connect a different telephone.
If there is no dial tone on this telephone either, the problem is in your wiring or local service.
Contact your local telephone company.
•
•
•
•