VTech VT9127 - Manual (Page 19)

19
ADV
ANCED OPERA
TION
OPTIONAL HEADSET INSTALLATION
Your VT9127 cordless telephone is equipped with a 2.5mm Headset Jack for use with an
optional accessory Headset for hands-free operation.
If you choose to use the Headset option, you must do the following:
INSTALLATION
* Obtain an optional accessory Headset, which is
compatible with the
VT9127 .
Please contact VTECH Communications Customer
Service, in the U.S. toll-free at 1-800-595-9511. In
Canada, call 1-800-267-7377 for dealer information in
your local area. You can also purchase a compatible
Headset directly from VTECH Communications
Customer Service.
* Once you have a compatible 2.5mm Headset, locate the
Headset Jack on the Handset of your
VT9127 . Connect
the plug on the Headset to the jack on the cordless
Handset(under a small rubber flap). The plug should fit
securely. Do not force the connection. See illustration.
OPERATION
NOTE: Whenever a compatible Headset is connected to the cordless Handset, the microphone
on the Handset will be MUTED. This is done to limit the effect of background noise.
BELT CLIP
* The VT9127 is also equipped with a detachable belt
clip. Align the pins on the inside edge of the belt clip with
the notches on the side of the
VT9127 Handset.
The belt clip should snap securely into place. Do not
force the connection. See illustration.
* To remove the belt clip, pry it away from either side,
where the pins are secured in the Handset notches.
Do NOT pull up from the bottom of the clip!!!