Philips SCD499 - Manual (Page 14)

Make sure the parent unit is dry before you put it back into the charger.
Clean the charger with a dry cloth.
Storage
You can use the travel pouch to store the baby monitor while you travel.
When you are not going to use the baby monitor for some time, remove the batteries and
store the parent unit, the baby unit, the adapter of the baby unit and the charger in the travel
pouch supplied.
environment
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. ).
Batteries contain substances that may pollute the environment. Do not throw
away batteries with the normal household waste, but hand them in at an official collection
point. Always remove the batteries before you discard and hand in the appliance at an official
collection point.
guarantee and service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic appliances and Personal
Care BV.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Customer Care Centre in your country.
Question Answer
Why don’t the ON light
of the baby unit and the
LINK light of the parent
unit come on when I
press the on/off buttons
of the units?
Perhaps the batteries of the parent unit are empty and the parent
unit is not in the plugged-in charger. Put the adapter of the charger in
the wall socket and place the parent unit in the charger. Then press
the on/off button to establish connection with the baby unit.
Perhaps the batteries of the baby unit are empty and the baby unit is
not connected to the mains. Replace the batteries or put the small
plug in the baby unit and put the adapter in a wall socket. Then press
the on/off button to establish connection with the parent unit.
The baby unit and the parent unit may be out of range of each other.
Move the parent unit closer to the baby unit, but not closer than 1
metre/3 feet.
If the LINK light on the parent unit still does not start to flash, use
the reset function to reset the units to their default settings.
,
,
,
,
EngliSh 1