Vidikron VL-32HD - Manual (Page 44)

Operation
34 Vidikron VL-26/VL-32 Owner’s Operating Manual
Add/Erase: If Auto Tuning fails to detect a channel, select Add/Erase from the Channel
menu, then select Add to add it to the channel list. To erase the currently-selected channel
from the available channel list, select Add/Erase from the Channel menu, then select Erase.
Fine Tune: Use the Fine Tune function to improve the reception of off-air channels.
Favorite Channel: You can specify up to four channels as “favorite” channels that can be
accessed by pressing a single button on the remote, instead of manually entering the
channel number. To do this, select Favorite Channel from the Channel menu and press
ENTER.
Use the up- or down-arrow button to select the memory location in which you want to store
the favorite channel. Then, use the left- or right-arrow button to specify the channel number.
To recall a favorite channel, press the corresponding button on the remote control (FC1, FC2,
FC3 or FC4).
Timer To set the DView internal clock or configure the on/off timers, select Timer from the Main
Menu and press ENTER.
Time: To set the DView internal clock, select Time from the Timer menu and press ENTER.
Use the up- or down-arrow button to select either the hour of the day or the minute of the
hour to set. Then, use the left- or right-arrow buttons to set that component of the time.
When finished, press MENU.
On Timer: Use the On Timer to turn the DView on at a specific time of day. You can also
specify a channel and a volume level.
Off Timer: Use the Off Timer to turn the DView off at a specific time of day.
Sleep Timer: Use the Sleep Timer to turn off the DView after a specified interval.
To set the Sleep Timer:
• Select Sleep Timer from the Timer menu and press ENTER. Use the right- or left-arrow
button to select 10, 30, 60, 120 or 180 minutes. Then, press MENU.
-- OR --
• Press the TIMER OFF button on the remote control repeatedly to select the desired timer
interval.
Setup Use the controls in the Setup menu to perform advanced image quality adjustments and
access various other DView features.
OSD Language: Select OSD Language from the Setup menu and press ENTER. Then, use the
up- or down-arrow buttons to select the OSD language (English, French, Spanish, Portuguese
or German). Press ENTER again to confirm your selection.
PC Mode Adjust: To improve the quality of projected images from a computer or other
VESA-compliant, RGB (480p or higher) source, select PC Mode Adjust and press ENTER.
• Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer images. To
execute Auto Adjust on command, select Auto Adjust and press ENTER.
Timer
Time
On Timer
Off Timer
Sleep Timer
➤
Setup
OSD Language
PC Mode Adjust
Caption
Parental Control
Letterbox Mode
Input Selection
Monitor Out
Overscan
➤
Auto Adjust may take some time to complete, depending on the
characteristics of the incoming signal.
Note