Vax X3 - Manual (Page 5)

4
Your cleaner contains a thermal protective device to shut off the motor to avoid overheating. If this happens, turn switch off and unplug the cleaner. Inspect
the exhaust, inlet, hose, and filters for any blockage. Empty the dirt container and clean filters. After approximately 30 minutes the motor will have
cooled and the vacuum will be ready to use. NOTE: The cleaner must remain unplugged during the 30 minute cooling period.
WARNING:
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Do not put any objects into openings. Do not use with
any opening blocked; keep free of dust, lint, hair, and
anything that may reduce air flow.
• Keep hair, loose clothing, fingers, and all parts of body
away from openings and moving parts.
• Do not pick up anything that is burning or smoking, such
as cigarettes, matches, or hot ashes.
• Do not use without dirt container and filters in place.
• Turn off all controls before unplugging.
• Look on your vacuum cleaner and follow all label and
marking instructions.
• Use extra care when cleaning on stairs.
• Do not use to pick up flammable or combustible liquids,
such as gasoline, or use in areas where they may be present.
• Keep the vacuum cleaner on the floor. Only the hand-
held vacuum cleaners may be set on furniture.
• Vacuum cleaner must be in the upright position to lift the
rotating brush off the carpet when doing above floor
cleaning.
• Do not use an extension cord with this vacuum cleaner.
• Store the vacuum cleaner indoors. Put the vacuum cleaner
away after use to prevent tripping accidents.
• Using improper voltage may result in damage to the
motor and possible injury to the user. Proper voltage is
listed on the cleaner plate.
• Hold plug when rewinding cord onto reel. Do not allow
plug to whip when rewinding.
• Unplug before connecting Turbo Tool.
• Do not carry vacuum cleaner by the cleaning wand tube.
This is not a carry handle.
SAVE THESE INSTRUCTIONS