Vivitar DVR 610 - Manual (Page 6)

5
When powering the digital camcorder ON for the first time, the camera takes you through the
INITIAL CAMERA SETUP.
Powering the Camera ON
1. Batteries
Make sure the batteries have been inserted properly into your digital camcorder.
Slide the battery cover on the back of the camera in a downward direction to open the
cover.
Insert 2 x AA (1.5v) batteries (not included) with the correct polarity, according to the
polarity illustrated inside the battery compartment.
Note: Alkaline batteries are recommended.
2. SD Memory Card
Make sure an SD card has been properly inserted into your camera. (SD card not
included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the
SD card slot). Push the SD card until you hear a slight clicking sound. This indicates the
SD card has been inserted correctly.
Note:

After the camera is powered on, an SD icon will appear on the LCD display. If you do
not see the SD icon on the display, please check if the card was inserted properly.

Make sure the SD card is not locked (check the lock switch on the side of the SD card). If
the SD card is locked this will prevent the camera from saving captured photos to the SD
card.
3. Power On
Press the POWER button, on the top of the camera, to turn on the camera.