VIEWSONIC VS12840 User Manual

Page 10

ViewSonic

VMP52

Instruction to install the built-in SATA(2.5’) HDD

1. Remove four hex screws from the rear (connector panel) us-

ng the suppled tool.

2. Slide out the rear cover, complete with circuit board. It may be

necessary to push gently from the front by removng the front

cover va four hex screws.

3. Place the SATA(2.5’) HDD closely at the back of circuit board,

then insert it into the SATA matching slot.

4. Tighten the screws on the SATA (2.5) HDD with the supplied

tool.

5. Slide the circuit board along with the board slot into the main

case, then tghten the screws on the man case.

Note:

1) Please format the SATA (2.5’) HDD before fitting it into

the player.

2) Make sure not to damage embedded components on the

crcut board.

3) After successful nstallaton, enter setup menu, and

choose “SATA” in device selection, for detailed instruction

please refer to Page 11.