Vinotemp VT-34-2ZONE - Manual (Page 11)

REVERSAL OF DOOR SWING
The door of the wine cellar could be opened either from the left or right
side. The wine cellar is installed to open from the left side.
To reverse, please do as follows:
1. Remove the hinge cover on top right side of the cellar, then remove
the bolts and take off the hinge, and put them to the side.
2. Take off the door accordingly and put it to the side gently.
3. Remove the plugs from the left side top of the cellar and insert them
into the hole on the right side.
4. Remove the hinge bracket on bottom right side of cellar, flip the
bracket over and then transfer it to the opposite side. Make certain
the leveling legs are properly adjusted.
5. Install the door. (Note: the door must be upside down to insure
proper installation).
6. Install the hinge on the top right side of the cellar, screw the bolts
tightly, and then install the hinge cover.
Note: Please remember, do not power up the unit for 48 hours, to allow
the coolants to settle inside the compressor.
OTHER OPERATION NOTES:
1. Always store wine in properly sealed bottles.
2. Do not overload the cabinet.
3. Do not cover shelves with aluminum foil or any other shelf material
which may prevent air circulation.
4. Should the wine cooler be stored without use for long periods, it is
suggested, after a careful cleaning, to leave the door ajar to allow air
to circulate inside the cabinet in order to avoid possible formations of
condensation, mold or odors.
11 1 7 6 3 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m