Staub Electronics DMS-100 URC - SINGLE ZONE AMPLIFIER - Manual (Page 15)

Page 13
DMS-100 S
YSTEM
C
ONFIGURATION
System Configuration for Internal LAN Network
Follow the steps below to connect a DMS-100 to a LAN network.
1. Connect the Internet to the coaxial CABLE port in the rear of the
cable modem.
2. Plug in a RJ-45 ethernet connector cable via the Ethernet port of
the cable modem to the WAN port of the Router.
3. Connect a second RJ-45 cable to a LAN port of the Router and
plug the other end to the LAN 10/100 port on the rear of the
MFS-8/MFSPOE-8 network Switch.
4. Connect a third RJ-45 cable to connect the DMS-100 LAN port to
one of the eight 10/100 Smart ports.
5. Plug the power supply to the DMS-100 and then plug it in to an
unswitched AC outlet.
6. Connect a PC computer to the same LAN (WLAN) as the DMS-100
or plug an ethernet cable directly to the LAN port of the DMS-100.
Now the computer can control and adjust the manufacturer’s audio
control program.
Select audio INPUT source and OUTPUT zone, MAC address etc.
This function selects input source channel and INPUT gain level
and data sent to audio equipment.
After selecting the output zone, adjust the zone limit power rate and
zone power ON/OFF and source signal INPUT channel.
Adjust the amplifier volume level per each zone for proper sound
output and maximum limitation volume level.
Turn on the ramp up volume level and adjust the equalizer repertory
and low volume loudness control effectiveness and custom equalizer align.
PC
Internet
Cable Modem
WiFi Router
MFS-8
DMS-100