U-Line SS1095FC - Manual (Page 9)

09/2008 9 www.U-LineService.com
SS1095
MARINE SERIES
14. Place the door latch assembly on opposite side of unit
(Figure 17). Be sure to tighten all three screws securely.
15. Place door on lower hinge pin. Invert and install upper
hinge on door. Fasten upper hinge to unit (three screws
(Figure 18). Partially tighten screws.
.
16. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
17. Replace screws in holes in bottom of unit on opposite
side.
18. Replace the grille.
Other Site Requirements
Power Supply
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A circuit (normal household current). See
Electrical Specifications on Page 11.
Water Supply
The unit requires a 1/4-inch OD water supply line and a
shut-off valve. For more information see Page 10.
Environmental Requirements
The surrounding air temperature must be at least 50°F
(10°C) but must not exceed 110°F (40°C). Units may be
installed outdoors in a covered area. The unit must not be
located near heat-generating equipment or in direct
sunlight.
Figure 17
ULIN_0145_A
Figure 18
4 Service