Uniden DS845 - Manual (Page 21)

15
If a handset is registered at
any time as handset 1, all
other handsets will need to
be registered again from
Step 1.
The original handset supplied with the Main Base is already registered as handset 1, this
leaves handset numbers 2 - 7 available. It is very important to allocate each handset a
different number to enable functions such as Call Transfer.
After Registration the
handset number is shown
on the Display screen either
during a call or while the
handset is charging (Fig 5).
The Registration process
needs to be completed
within 15 seconds, 3 beep
tones will indicate that the
time has been exceeded.
Please start the process
again.
Handset
Registration
number
displayed
HANDSET: 1
NEW:
1
TOTAL: 1
TALK HIGH 1
Fig 4.
Fig 5.
Charging On a Call
REGISTER AS
HAND #2
REGISTER AS
HAND # (3 - 7)
Fig 2.
Fig 3.
Fig 1.
Registration Process
Follow this process for each additional handset (DS805) that needs to be registered to the
Main Base or for registering your Main Handset.
1. Remove the handset from its charger
2. Press flash/reg on the handset (Fig 1).
3 Press the number 2 (Fig 2) for handset 2.
4. Place the handset in the Main Base Unit (Fig 4).
REGISTRATION
If you have additional
handsets, repeat the same
process, but at Step 2 select
a number from 3 - 7 to
register the next handset as
(fig 3)