Anti-tip kit installation, Installation troubleshooting, 11 install unit – U-Line 2275DWRW User Manual
Page 15
U-Line Electrical / Plumbing Specfications
13
1. Plug in the power cord.
2. Open the top drawer and press the POWER icon to turn the
unit OFF.
3. C2275DWR Only: Open the water supply valve in the main
water source.
4. Gently push the unit into position. Be careful not to entangle the
electrical cord.
5. Re-check the leveling, from front to back and side to side. Make
any necessary adjustments. The unit’s top surface should be
approximately 1/8" below the countertop.
Anti-Tip Kit Installation
WARNING
• The Anti-Tip Kit must be installed on this unit before
it is used.
• Additional blocking or special fasteners may be
required for installation. Installer is responsible for
secure attachment to prevent the unit from tipping.
• Make sure the mounting screws attaching the unit to
the counter, cabinet or wall are deep enough into the
mounting surface to support the weight of the
drawers and the items that will be inside the drawers.
• Never use the drawers as steps or as a shelf to
support more than the drawers’ content. Serious
personal injury could occur.
After leveling, the unit must be secured to a counter, a cabinet or a
wall to prevent tipping.
1. Open the upper drawer to expose the six screws (A) installed
at the top two corners (three at each corner). Remove the
appropriate screws for horizontal or vertical mounting Do not
discard.
2. Insert the screws through the anti-tip bracket (B) and attach the
bracket to the unit. Tighten screws securely.
3. Repeat for the other side.
Note: The bracket should be flush with the surface it is being
attached to. If it is not, loosen the screws and slide the bracket
against the mounting surface. Tighten screws securely.
4. Using two of the screws (C) supplied, fasten the screws through
the bracket and into the counter, cabinet or wall.
IMPORTANT
IMPORTANT
Certain cabinets or countertops may require special
fasteners or additional wood blocking to anchor properly.
CAUTION
Make sure the screws are back far enough so they do not
damage any exposed front surface of the cabinet.
Installation Troubleshooting
Problem
Q:
The drawer remains open unless it is pushed closed.
Solution
A:
The drawer should be self-closing when it is open approximately
8". If it is not, re-check leveling from front to back of the unit and
readjust if necessary.
Problem
Q:
Water is leaking under the unit (C2275DWR units)
Solution
A:
A water leak under the unit is most likely caused by a bad
connection in the water supply line. Make sure the water line’s
brass fitting is screwed tight to its valve and threaded correctly.
11 Install Unit
A
B
Countertop or Wall Header
C
Cabinet or Wall Stud
A
C
B
Horizontal Mounting
(Left Side Shown)
Vertical Mounting
(Left Side Shown)