beautypg.com

U-Line 2275DWRW User Manual

Page 11

background image

U-Line Drawer Panel Installation

9

Attaching the Full Overlay Panel

1. If user-supplied cabinet handles will be used, attach their

hardware to the overlay panel at this time.

IMPORTANT

IMPORTANT

User-supplied cabinet handles MUST be counter bored to
make sure mounting hardware is below surface of overlay
panel. Failure to do so can cause damage to overlay panel
and/or drawer. Overlay panel will not sit flush to drawer if
mounting hardware is not counter bored.

2. Place and tape the existing drawer panel on the back of the

overlay panel (see above).

3. Drill the five holes (5/32" drill 3/8" deep) through both panels

according.

CAUTION

It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.

4. Remove tape adjoining the panels and enlarge the five holes in

the overlay panel using a 0.201" (#7) drill.

5. Attach the drawer panel to the overlay panel using #10 x 5/8"

wood screws and nylon spacers. The nylon spacers fit between
the overlay panel and the door panel as shown in Figure 11. The
spacers allow the original drawer panel to slide back into the 1/
4"-thick drawer front reveal (channel).

IMPORTANT

IMPORTANT

Drawer panel and overlay panel must be aligned properly
or the drawer will not operate correctly.

Assembling the Drawer Front

1. Install the assembled panel by sliding the original door panel

back into the drawer front.

2. Replace the handle assembly and secure with the two screws

removed in Step 2 under Removing Existing Drawer Fronts.

3. Starting at the corners and working toward the center, push the

drawer gasket back into place. Go on to 5 Adjust Drawers.

Drawer Panel

Bottom of

Wood Panel

Back of

Wood

Panel

Side of

Wood Panel

Tape

11/32"

Bottom

3/8"

Both Sides

Top of

Wood Panel

14-3/4"

1"

11-7/8"

1"

23-3/4"

5/32" x 3/8" Deep –

5 Places

Vinyl Coated

Steel Panel

11-13/16"

1"

2-15/16"

Drawer Panel

Typical

Wood Panel

Plastic

Spacer

Five

Required

#10 x 5/8"

Round Head Screw

Five Required

This manual is related to the following products: