Uniden DCX 770 User Manual
Page 4
–
4
–
Step 2: Register the Handset
YOU NEED TO REGISTER THE DCX770 TO A MAIN BASE BEFORE USE!
1
Be sure the handset battery is fully charged.
2
With the main base in standby mode (i.e., not being used), place
the handset in the main base to begin registration.
For compatible models in the DCT6 and DCT7 series:
1)Disconnect the AC adapter.
2)While holding the following key, connect the AC Adapter:
DCT646 & DCT746 models - find handset
DCT6465 & DCT6485 models - intercom
DCT648 models - intercom/find handset
DCT748 models - find/skip
Keep pressing the key until the CHARGE LED starts to blink.
3)On the handset, press and hold # until you hear beep.
For compatible models in the DCT7488 series:
1)Press the MENU soft key in the standby mode.
2)Select
HS R e gi s tr a ti on
, and press the OK soft key.
3)On the handset, press and hold # until you hear beep.
3
While the handset is registering,
Ha nd s et Re g is t er in g
will
appear in the handset LCD. When
Re g is t ra ti o n C om p le te
is
displayed, the handset has been registered to the base.
If
R eg is t ra t io n F a il ed
appears, please try these steps again.
De-register the handset
1)Press and hold end and # for more than 5 seconds.
2)Select the handset ID to be de-registered from the list.
The phone will ask you to confirm the deregistration. Select
Y e s
.
To de-register expansion handsets DCX640 or DCX700, refer
to their owner's manual or download from Uniden's website
at www.uniden.com.