Uniden BC-RH96 - Manual (Page 16)

16
Operation
Apply power to your target scanner and set its Baud
Rate to the highest setting. Make sure that the Remote
Control cable is properly connected, and rotate the
VOL control clockwise past OFF until it clicks.
The LCD displays the following screens (your version
number may be different than the screen shown here):
If you have not connected a target scanner, you see
the screen below. If the BC-RH96 remains on while
you turn on the scanner, this display is automatically
replaced with the scanner’s initial display.
$%4*
2TGUU/'07-G[
HQT%QPHKI
7PKFGP$GCTECV
$%4*
8GTUKQP
$%4*
7PEQPPGEVGF
5ECPPGT