UNICOM Electric 802.11b+g - Manual (Page 33)

- 30 -
Appendix
Soft AP Configuration
Setup Requirement:
To bridge your wired and wireless network using 802.11b+g Wireless LAN USB
Adapter, the following must be met:
1. Install the 802.11b+g Wireless LAN USB Adapter on the LAN-connected
computer.
2. The Soft Access Point should be connected to a network switch, hub or a
Broadband Router. Use a standard Category 5 UTP Ethernet cable with an
RJ-45 connector to connect the Soft Access Point to one of router, hub, or
switch.
3. The computer that you are installing the wireless card into has an Ethernet
connection, and is connected to a LAN with a DHCP server.
SoftAP Configuration：