Uniden FP103 - Manual (Page 5)

For Caller ID to operate you
must first subscribe to a
Caller ID service from your
telephone company.
SET UP
NOTE
If you subscribe to a Caller ID
service, the time and date will
be automatically updated when
the first CID information is
received. You do not need to
set it manually.
Back-up Battery Installation
1. Remove the two screws on the battery compartment cover under the base.
2. Remove the cover and attach the connector to the battery.
3. Position the battery in the compartment and replace the cover and screws.
The battery will keep information without the power adaptor for 6 months. on
the screen means the battery is low, you should replace the battery within 7 days.
Connecting Line Cords
Plug one end of the supplied modular cord into the telephone wall jack. Then plug the
other end into telephone base line jack.
Caller ID Insert ‘0’ On/Off
On some telephone networks, to correctly display and dial Caller ID telephone numbers,
a ’0’ may need to be inserted. When the power is first connected to the FP103
CID insert
‘0’ off is displayed. If it is not displayed, press the reset button, located at the rear of the
telephone base. You may select ‘on’ or ‘off’ by pressing the up or down buttons followed
by the store button.
New Zealand: Telecom - insert ‘0’ on. Australia: Insert ‘0’ off.
Flash Time
After the caller ID insert ‘0’ option is set the screen will display . Select either
100 or 600 by pressing the up or down buttons, followed by the store button.
New Zealand: 600 Australia: 100
LCD Contrast
1. Press and hold the store button for approximately 2 seconds until the screen displays
LCD CONTRAST .
2. Press the up or down buttons to adjust the LCD display contrast to the desired viewing
level.
3. Press the store button to set and move to the next menu option or press cancel button
to save and exit.
Setting Time and Date
1. Press and hold the store button until the screen displays
LCD CONTRAST .
2. Press the store button again - the screen displays SET TIME/DATE .
3. Press the up or down buttons to move the curser. Press the appropriate number to enter
the time and date. Press * (am) or # (pm). HH : MM MM / DD
If you make a mistake, use the up or down buttons to move the cursor and re-enter the
correct information.
4. Press the store button to set and move to the next menu option or press cancel to
save and exit.
LOW
]
]
Telstra/Saturn - insert ‘0’ off.
4
(hours : minutes) (day : month)
]
] ]
] ]
]
FLASH TIME
] ]
12:15
S E T T I M E / D AT E
AM 01:08