Universal Electronics Atlas 4-DEVICE Universal Remote Control - Manual (Page 22)

22
PROGRAMMING ID LOCK
The Atlas Universal Remote Control is preprogrammed
and locked at the factory to operate a Scientific Atlanta
cable converter.
However, if you have another brand or model of cable
converter and interactive service that you would like to
control, then you’ll need to perform the following steps to
unlock the cable ID Lock, enter in a new manufacturer’s
code, and lock the ID Lock again.
1. Turn on the cable converter.
2. On the remote control, press CBL once.
Then press and hold SETUP until the
CBL key blinks twice, then release SETUP.
3. Enter 9 - 8 - 2. The CBL key will blink
four times.
4. Perform the instructions in Programming
Device Control on page 8 to program device
control for the desired cable converter and
interactive service. Upon completion, perform
the remaining steps (5 and 6 on this page) to
again lock the ID lock.
5. On the remote control, press CBL once.
Then press and hold SETUP until the
CBL key blinks twice, then release SETUP.
6. Enter 9 - 8 - 2. The CBL key will blink twice.
Atlas Manual 4/8/02 9:37 AM Page 22