Uniden DCT646 - Manual (Page 3)

– 3 –
Install the Rechargeable Battery
Pack into the Handset
Follow these steps before using your cordless handset:
• Make sure the handset is registered to main base unit.
• Fully charge the battery pack.
1 Press down on the handset battery
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
2 Plug the battery pack connector (red
& black wires) into the jack inside the
battery compartment. (The connector
notches fit into the grooves of the
jack only one-way.) Match the wire
colors to the polarity label in the
battery compartment, and push the
connector in until you hear a click.
3 Make sure you have a good connection
by slightly pulling on the battery wires.
If the connection is secure, the battery
jack will remain in place.
4 Place the battery case cover back on
the handset by sliding it upwards
until it clicks into place.
5 Place the handset in the charging
cradle with the keypad facing forward.
• Use only the Uniden battery (BT-446)
supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department.
(See page 2.)
• Recharge your handset on a regular
basis by returning the handset to the
charger after each phone call.
Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly