Uniden DECT3380 - Manual (Page 15)

15
The phone defaults to a capital letter for the first letter and any
letter after a space; otherwise, it uses small letters.
To switch to all capital letters, press
*
. The phone defaults to all
capital letters first (e. g. ABCabc2) until you enter a blank space or
press
*
again. (Any time you want to change case, just press
*
.)
If two letters in a row use the same number key, enter the first
letter and wait a few seconds (or press righT ); the cursor will
move to the next space. Enter the next letter.
Press
# to enter a blank space.
To change a letter, move the cursor to that letter and press CLEar
to erase the letter. Then, enter the next letter.
To erase the entire entry, press and hold
CLEar .
Press 0 to cycle through all available symbols and punctuation.
USING YOUR PHONE
You can control the features in this section through the handset.
Learning the Basics
To...
Do this
from the earpiece... from the speaker...
make a call: Dial the
number, then
Press TaLk/fLash . Press sPEakEr .
answer a call Press TaLk/fLash . Press sPEakEr.
hang up Press End or put the handset in the cradle.
mute the microphone
during a call Press MuTE . Press again to turn the microphone
back on.
put a call on hold
Press CLEar/inTErCoM . After 5 minutes on hold,
the call will be disconnected.
return to a call on
hold
Press TaLk/fLash . Press sPEakEr.






