Ultra Products 93900 - Manual (Page 8)

8
To Verify Windows NT 4.0 Installation
1. Double click My Computer/Control Panel/SCSI
Adapters.
2. Highlight Silicon Image SiI 0680 ATA/133
Controller from SCSI Adapters listing and click
Properties. A message This device is working properly
is displayed in the dialog box, the driver has been
correctly installed.
Windows 2000
For New Windows 2000 Installation
1.
Install the board and follow Microsoft procedures to
install Windows 2000 accordingly.
2. Restart your system when prompted during
Windows' installation.
3. At the Windows 2000 Setup screen, press F6 to
install the driver.
4. Insert the driver diskette. Press S, then press Enter.
5. Select Silicon Image SiI 0680 ATA/133 Controller
and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete installation.
For Existing Windows 2000 Installation
1.
Install the board and boot up Windows 2000.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended) and click Next.
4. Insert the driver diskette, check Floppy disk drives,
uncheck the other boxes, and click Next. Click Next
again to continue.
5. Click Finish, remove the driver diskette and restart
Windows to complete driver installation.