Uniden DECT3181 - Manual (Page 4)

4
Do not use the telephone to report a gas leak in the vicinity of the
leak.
Use only the power cord and batteries indicated in this manual.
Do not dispose of batteries in a fire. They may explode. Check with
local codes for possible special disposal instructions.
Do not place the handset in any charging cradle without the battery
installed and the battery cover securely in place.
SAVE THESE INSTrUCTIONS!
CAUTION! risk of explosion if battery is replaced by an
incorrect type! Dispose of used batteries according to the
instructions. Do not open or mutilate the battery. Disconnect
the battery before shipping this product.
For more details, see the Important Information section.
GETTING STArTED
Installing Your Phone
Charge the battery
Unpack all handsets, batteries, and
battery covers. If you need to remove a
battery cover, press in on the notch and
slide the cover down.
Line up the battery connector with the jack inside the handset and
push the connector in until it clicks into place. Tug gently on the
wires to make sure the battery pack is securely connected.
Replace the cover and slide it up into place.
Connect the base AC adapter to the
ac in 7.8V jack on the base. Run
the cord through the indent and out the back.
If you have accessory handsets, connect each charger’s applicable AC
adapter to the power jack.
If you have a DRX312 handset with a MULTIRANGE charger or
a DWX317 waterproof handset, be sure to use the correct AC





1.
2.
3.
4.
5.
