Uniden DSS 2455 - Manual (Page 69)

[ 63 ]
TROUBLESHOOTING
If your phone is not performing to your expectations, please try these simple steps first.
Symptom Suggestion
The charge LED won’t illuminate • Make sure the AC adapter is plugged into the base (or the charger
when the handset is placed in
(for DSS2465 only)) and wall outlet.
the cradle. • Make sure the handset is properly seated in the cradle.
• Make sure the charging contacts on the handset and the base
(or the charger (for DSS2465 only)) are clean.
The audio sounds weak • Move the handset and/or base to a different location away from metal
and/or scratchy. objects or appliances and try again.
• Make sure that you are not too far from the base.
Can’t make or receive calls. • Check both ends of the base telephone line cord.
• Make sure the AC adapter is plugged into the base and wall outlet.
• Disconnect the AC adapter for a few minutes, then reconnect it.
• Remove the base ID (see “Deregister the Base Setting” on page 22) and
register the handset to the base (see “Register the Handset” on page 56).
• Make sure that you are not too far from the base.
• If an outside call is already established, you may not be able to make another
outside call.
Can’t make an internal call. • Make sure that the receiving handset is not already in use.
• Make sure that the handset or the base is in the standby mode.
• When a handset is recording a conversation, an intercom call from or to the
base is not available. Make sure a handset is not recording a conversation.
UP308BH (DSS2465) ENG OM 1/14/05 11:49 AM Page 63