Uniden DECT2060 User Manual

Page 22

Registering the Handset to Another Base

To.register.a.handset.to.another.base:

Make.sure.the.handset.battery.is.fully.charged.
On.the.base,.disconnect.the.base.AC.adapter..Then.press.and.hold.

[find hs].while.you.reconnect.the.adapter..

Keep.pressing.

[find hs].until.the.charge.LED.starts.to.blink.

On.the.handset,.Press.

[Menu/Select]..Select.the.REGISTER.BASE.menu..HANDSET.REGISTERING.will.

appear.in.the.display.
Wait.approximately.thirty.seconds..“REGISTRATION.COMPLETE”.will.be.displayed.to.indicate.the.handset.has.

been.registered.to.the.base.and.a.handset.ID.will.be.automatically.assigned.

If.REGISTRATION.FAILED.appears.in.the.LCD,.please.try.these.steps.again.

Selecting the Base

When.your.handset.is.registered.to.another.base,.it.will.automatically.connect.to.the.base..A.base.ID.(that.is.for.the.

handset.only).will.be.assigned.in.the.order.of.registration..You.can.either.select.a.base.you.want.to.use.manually,.or.

set.to.AUTO..If.you.set.to.AUTO,.when.the.handset.comes.out.of.range,.it.searches.automatically.the.available.base.

in.order.of.base.ID.

With.the.phone.in.standby,.press.

[Menu/Select]..Select.the.HANDSET.SETUP.menu,.and.then.the.SELECT.

BASE.submenu.
Move.the.cursor.to.select.the.base.you.want.to.connect.to,.or.choose.AUTO.to.have.the.handset.automatically.

select.the.base.
Press.

[Menu/Select]..SEARCHING.will.appear.in.the.display.

When.the.base.is.found,.the.handset.will.return.to.standby..If.the.base.is.not.found,.“SEARCHING”.continues.

to appear. You can repeat the procedure listed above to return back to the original connection or to find the

different.base.

Notes:.•.You.cannot.change.bases.during.a.call..

• To confirm which bases the handset is registered to, open the SELECT BASE submenu and use

[ ].and..

[ ].to.scroll.through.the.list..Press.[ ].to.close.the.list.and.return.to.standby.

)
2)

)

3)
4)