Universal Electronics C6 - Manual (Page 12)

R EMEMBER
• I F THE LISTED DEVICE ’ S M ANUFACTURER C ODES DO NOT WORK , TRY
“S EARCHING FOR Y OUR D EVICE ’ S M ANUFACTURER C ODE .” S EE BELOW .
• I F THE ORIGINAL REMOTE CONTROL FROM YOUR VCR DOES NOT HAVE A
P OWER KEY , PRESS P LAY INSTEAD OF P OWER ON STEP 6.
• Y OU CAN ALSO SET UP A SECOND TV, CBL , DVD, AUX, VCR, OR AUD.
S EE “R EASSIGNING D EVICE M ODE K EYS ” ON PAGE 21.
Searching for Your Device’s
Manufacturer Code
If you have tried all of your Device’s Manufacturer
Codes and your device still does not respond to
the Kameleon-C6 Remote,“Searching for Your
Device’s Manufacturer Codes” allow you to manu-
ally find the Manufacturer Code for your device.
Kameleon-C6 Remote can cycle through all the
codes in its code library memory until it finds a
code that properly operates the device you wish to
program.
TO SEARCH FOR YOUR DEVICE’S
MANUFACTURER CODE
1. Turn your device on.
2. Press the desired device mode key on your
Kameleon-C6.
3. Press Setup for at least 3 seconds. The bottom
of the IR indicator will blink twice.
4. Press 9 9 1 on the keypad. The bottom of the IR
indicator will blink twice.
5. Aim your remote at your device and press the
device mode key followed by Power.
5a. If your device turns off, press and release the
Setup
key to store the code.
5b. If your device does not turn off, press the
device mode key to cycle through the next set of
codes and press Power again.
Repeat step 5b until you find the code that turns
off your device.
R EMEMBER
• K EEP THE REMOTE POINTED AT YOUR DEVICE WHILE REPEATING THE
STEPS . P LEASE BE PATIENT .
• I F A KEY IS NOT PRESSED WITHIN 30 SECONDS DURING S TEP 5, YOUR
K AMELEON -C6 R EMOTE WILL EXIT THE S ETUP MODE AND RETURN TO
THE PREVIOUSLY SELECTED CODE .
• I F THE ORIGINAL REMOTE CONTROL FROM YOUR VCR DOES NOT HAVE A
P OWER KEY , PRESS P LAY INSTEAD OF P OWER IN STEP 5.
12 Searching for Your Device’s Manufacturer’s Code
K
AMELEON
-C6 R
EMOTE
Kameleon C6_v10.qxd 5/14/03 9:16 AM Page 12