Uniden BTS200 - Manual (Page 6)

6 - English
1. Press and hold for at least 3 seconds.
2. All LEDs light and a power on tone sounds.
3.
and LEDs go out.
4. flashes slowly while looking for Bluetooth devices. It remains steady on when
Bluetooth devices are discovered; otherwise, it goes out.
To turn off the speaker: Press and hold for at least 3 seconds.
Pair Bluetooth Devices to Your Speaker
Pair First Bluetooth Device
Pair your first Bluetooth device to your speaker when you turn your speaker on for the first
time. Be sure your speaker is in pairing mode when you pair your second Bluetooth device
(see step 1-2 of “Pair Second Bluetooth Device” on page 7).
1. Select a Bluetooth V2.1 or above device (mobile phone or music player) to pair.
2. Select the Searching mode on your Bluetooth device (refer to your Bluetooth device’s
owner’s manual for details if necessary).
3. Your Bluetooth device should find BTS200; select it and use 0000 for a pairing code if
necessary.
4. Verify that you are connected to your speaker. The Bluetooth LED ( ) moves to a
steady ON state when pairing is complete.