Uniden DECT2185 - Manual (Page 16)

Enter the code number (up to 20 digits) into the phonebook just
like a regular phonebook entry. Be sure to enter the code number
into the phonebook exactly as you would enter it during a call.
When you hear the prompt that tells you to enter the number, open
the phonebook and find the entry that contains your code number.
Press MENU/sELECT to transmit the code. Or, if you change your
mind, use pHoNEbook/LEfT to close the phonebook.
Finding a Lost handset
With the phone in standby, press fINd HaNdsET/INTErCoM on the base.
Select the handset you want to find (or All to page all handsets). The
paged handset(s) beep for 1 minute or until you press fINd HaNdsET/
INTErCoM again or press TaLk/fLasH followed by ENd on the handset.
Using Special Features
Using Do Not Disturb
The Do Not Disturb or DND feature turns off the ringers of the
base and all handsets at the same time.
With the phone in standby, press and hold do NoT dIsTUrb on the
base. The phone automatically turns on the answering system and
shows Do Not Disturb in the display on all stations.
To cancel, press do NoT dIsTUrb again.
If you turn the answering system off while dNd is on, the phone
turns off dNd along with the answering system.
Using Call Block
If you subscribe to Caller ID, you can save phone numbers to the call
block list. When a call comes in, the phone compares the received
phone number to the numbers on the call block list. If the phone
number is on the list, the phone replaces the caller's name with Call
Blocked and disconnects the call. (The caller hears a reject tone.)
The call block list holds 20 entries, and all stations share the same
list. You can add entries through the Call Blocking menu, by selecting
Add Call Block in the CID menu, or by blocking incoming calls. (Only
one station can edit the call block list at a time.)
Blocking incoming calls
When the phone rings, wait until the display shows the Caller ID
information (usually after the second ring). If you want to block the




