Uniden DECT2185 - Manual (Page 12)

0
To Follow these steps
Erase one letter
Move the cursor to the letter you want to erase and
press CLEAr ( CLEAr/INTErCOM on the handset; CLEAr/
MUTE on the base).
Erase the entire entry Press & hold CLEAr .
Enter punctuation or a
symbol
Press 0 to rotate through the available symbols.
Using Your Phone
To... From a handset From a handset
speakerphone
From the base
speakerphone
make a call: Dial
the number, then
Press TALK/FLASh . Press SPEAKEr . Press SPEAKEr .
answer a call Press TALK/FLASh . Press SPEAKEr . Press SPEAKEr .
hang up
Press END or put the handset in the
cradle.
Press SPEAKEr .
switch between the
speaker & earpiece Press
SPEAKEr . Press SPEAKEr . NA
mute the micro-
phone during a call
Press MESSAGES/MUTE . Press CLEAr/MUTE .
Press again to turn the microphone back on.
put a call on hold
Press CLEAr/INTErCOM .
Press FIND hANDSET/
INTErCOM .
If the call is on hold for 5 minutes, it will be disconnected.
return to a call on
hold
Press TALK/FLASh . Press SPEAKEr . Press SPEAKEr .
mute the ringer for
this call only
While the phone is ringing, press
MESSAGES/MUTE .
While the phone is
ringing, press CLEAr/
MUTE .
Changing the Volume
You can set the volume of the ringer and speaker separately for the
base and each handset; you can also set the earpiece volume on
each handset. For each item, press Up to make it louder or doWN to
make it softer. The available volume levels and how change them are
listed below: