Unisar Prenatal Heart Monitor - Manual (Page 5)

5. When you record your own heartbeat to play to your newborn, reduce
the volume as your heartbeat is much louder than you unborn baby’s.
We suggest making a 30-minute recording of your heartbeat.
TROUBLESHOOTING
If your unit is not working properly, please check the following:
1. Activation button is not held down during listening.
2. Volume control is too low.
3. Battery and/or headphone connection is not complete.
4. Foreign matter is in the listening cone.
5. Weak battery (ON/OFF LED signal will be dim).
6. Feedback/squealing noises – turn down the volume and/or move the
headphones further away from the Monitor. Press activation button only
when the Monitor is against your body.
7. Foam cover is not in place on the listening cone.
The Prenatal Gift Set is a Personal Care Product
and cannot be returned to the retailer. All exchange and refund
requests should be directed to our Help Desk.
If you are having difficulty, have questions, or
need assistance, call our Help Desk toll free at
1-888-232-6476 Mon-Fri from 9:00AM-5:00PM EST
Please read on
INSTRUCTIONS
For Listening (Please refer to diagrams on P. 10-11):
1. Make sure the foam cover is in place on the listening cone.
2. Remove battery compartment door and install a new 9-volt alkaline
battery (not included), keeping the ribbon under the battery and exposed
for easy removal. Press battery forward and down. Be sure to use a
new battery as an old one will severely interfere with the performance
of your Monitor.
3. Insert the headphone plug into either jack on the Monitor.
4. Turn on the Prenatal Heart Listener
® using the ON/OFF volume control
switch. The red LED will light to indicate the unit is in the ON position.
5. Use the Monitor on bare skin in a quiet room.
6. Hold the cone to your stomach or lower back (near your kidneys) and
press and hold down the activation button. Adjust the volume to optimize
the listening level and amplification. Start with a low to moderate setting
to avoid static.
7. If you do not hear the heartbeat, release the activation button and gently
move the Monitor one inch at a time to different places until you find
the best position for listening to your baby’s sounds. Start two inches
below and a little to the right of your belly button. Always release the
activation button when you are moving the Monitor across your stomach
or back.
For Recording:
1. To record these sounds plug the L-shaped end of the recording cable
into either jack of the Monitor and the straight end into the line input
of your tape recorder. (Some portable recorders do not provide this
input.)
2. Position the Monitor on your bare skin so you can hear the sounds you
wish to record.
3. Adjust the recording level on your tape recorder if necessary.
4. Hold the Monitor very still and begin recording.
8 9