Uniden DECT1580 Series - Manual (Page 51)

50 51
Using the
Answering
System
To.operate.from.a.remote.location,.use.any.touch-tone.telephone,.and.follow.these.steps:
Call.your.telephone.number.and.wait.for.the.system.to.answer..If.the.answering.system.is.off,.it.will.answer.after.
about.ten.rings.and.sounds.a.series.of.beeps.
During.the.greeting.or.the.beeps.(if.answering.system.is.off),.press.0.and.enter.your.security.code/PIN.within.
two.seconds.
The.answering.system.announces.the.current.time.and.the.number.of.messages.stored.in.memory..
You.hear.“To.play.incoming.messages,.press.zero-two..For.help,.press.one-zero”.followed.by.a.beep.
Enter a remote command from the chart below. You have fifteen seconds to enter the first command; after the
first command, you have two seconds to enter each command.
If you want to Press If you want to Press
Play.incoming.
messages
0.then.2.
The.answering.system.plays.back.
messages.for.four.minutes,.then.
waits.for.another.command..To.
continue.playing.your.messages,.
press.0.then.2.again.
Stop.the.current.operation.to.
enter.a.different.command.
0.then.5
Repeat.this.message. 0.then.1 (after the first four
seconds.of.this.message)
Turn.the.answering.system.off 0.then.9
Go.back.to.the.
previous.message
0.then.1 during the first four
seconds.of.a.message.
Turn.the.answering.system.on 0.then.6
Skip.this.message 0.then.3 Listen.to.the.help.prompts 1.then.0
Delete.this.message 0.then.4 Exit.the.system Hang.up.
When you finish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within fifteen seconds.
Hang.up.to.exit.the.system..The.answering.system.automatically.returns.to.its.normal.standby.setting.
1)
)
3)
4)
5)
6)