Ulead KDC330 - Manual (Page 11)

21 20
● If there is no sufficient memory, Memory Full is displayed in the LCD screen, and
taking pictures is impossible.
In this case, take pictures by inserting a new C/F card after turning off the power,
or take pictures when the capacity of memory is sufficient by deleting pictures
saved in the C/F card, after saving them in other devices (Computer hard disk
and other storage units).
Checking Battery Capacity Indication
When the power is supplied to the camera, you can see an indication in the shape of
a battery on the LCD panel.
Full — fully charged.
low — not fully charged.
Exhausted (blinking) — The Camera stop
working. Replace the batteries.
Checking Available Memory
◎ Even though you purchase a new C/F card, you need to
format the card when you use it at the initial stage.
HQ L
ML EV
0/3 T
W
◎ We recommend using a rechargeable battery (nickel
hydrogen), and an alkaline battery may be used as a
supplementary battery.
◎ If the power is turned off while a new battery has not been
replaced in the case of using the nickel hydrogen battery, the
power may be turned off when the lens has been protruded.
� Switch the camera on by pressing the Power
On button for about 1 sec. Set the mode
selection dial to auto still capture mode
� After waiting for a while until power indicator
(flash) is turned on, determine a picture frame
through either the viewfinder window or the
LCD display.
�Set the subject within the square of the LCD monitor when taking pictures.
�By using zoom or , you can zoom in or out the screen to capture.
Normal Shooting
HQ L
ML EV
0/3 T
W
Power button
T W
T
W
The subject is closer in the ZOOM IN (TELE) status.
The subject is further in the ZOOM OUT (WIDE) status
If you set digital zoom in camera setting mode, the subject
will be twice the size with added digital movie effect as well as
3 times larger optical zoom in case of pressing the
Button.
Button
Button
Digital Zoom
T