Unisar AC401-2P - Manual (Page 7)

When charging is complete, turn the Parents’ Unit on by pressing the Power button for two
seconds. The display will turn on and the channel will be displayed for 10 seconds. Then the
temperature of the nursery will be displayed. (If this fails to happen, you may need to reestablish
the connection between the Parents’ and Nursery Units. Please refer to the Parents’ Unit and
Nursery Unit Connection section on Pg. 13.) If the Parent’s Unit is turned on while the Nursery
Unit is off, the Nursery Unit symbol will flash and “
” will appear. After one minute, the Parents’
Unit will beep and shut down automatically. To manually turn off the Parents’ Unit, press the
Power button for three seconds.
Recharge the Parents’ Unit when the Low Battery symbol appears
(see fig. 11) and a beep is heard every 15 seconds for approximately 30
minutes. After approximately 30 minutes, the unit will shut down.
For long periods of non-use, we suggest removing the batteries and
unplugging the AC adapters.
Optional Feature Symbols
The monitor’s optional features are controlled by the Parents’ Unit and their symbols can be
seen on the LCD. These features are preset to the following:
If you would like to keep these settings and not make any changes, please turn to the Testing
Your Monitor section on Pg. 11. If you would like to change any settings, please continue with
the following section. Be sure to save this manual for future reference.
fig. 11
Feature Symbol Default Setting
Sound Monitor
Movement Sensor
“Tic” feature
Out-of-Range Indicator
Voice Activation
Voice sensitivity level
Sound Alarm
Vibration Alarm
Room Temperature Control
Low Temperature setting
High Temperature setting
Speaker volume level
ON
ON
OFF
OFF
OFF
2
ON
ON
OFF
59ºF
86ºF
3
F
- -
7