Unisar TV984 - Manual (Page 6)

Using Your Monitor
1. Turn the camera and receiver on by sliding the Power switches to the ON positions.
The green Power Indicator on the camera will light up when it is on. One of the Channel
Indicators on the monitor will light up when it is on.
2. Make sure the switch on the camera is set to “camera.”
3. Rotate the camera head so it faces your baby. To install the camera on the wall, use the
mounting screws and anchors with the mounting template provided.
4. Tilt the receiver to the desired viewing position. To install the receiver on the wall, use the
mounting screw and anchor provided.
5. For daytime vision, place the camera up to ten feet from your baby making sure it is out
of reach.
6. For nighttime vision, place the camera no more than six feet from your baby making sure
it is out of reach. The camera has a built-in light sensor which will automatically turn on the
night vision feature when there is no light detected. Remember, when using the infrared
night vision, the image will only be in black and white.
7. Select the channel that gives you the best reception. Make sure both units are on the
same channel.
8. If you have two cameras, you can monitor two different rooms. Set one camera to channel
A and one to channel B. Change the channel on the receiver to determine which room
you want to monitor. You can also set the receiver to automatically scan between the two
cameras. Please refer to the Automatic Channel Scan section on page 7.
9. Use the up and down buttons on the right side of the receiver to adjust the brightness.
To adjust the contrast and color, please refer to the Brightness, Contrast, and Color
Adjustment section on page 7.
10.Turn the volume dial on the top right corner of the receiver to the desired level.
6